B-MAX 2012 – Engine – 1.0L EcoBoost (74kW/100PS)/1.0L EcoBoost (90kW/120PS)/1.0L EcoBoost (103kW/140PS) (YY) – Camshafts – Removal and Installation

Engine - 1.0L EcoBoost (74kW/100PS)/1.0L EcoBoost (90kW/120PS)/1.0L EcoBoost (103kW/140PS) (YY) - CamshaftsB-MAX 2012.75 (01/2012-)
Removal and Installation

Special Tool(s)

Click to resize E141996

303-1605
Alignment Tool, Camshaft
Materials
NameSpecification
????????? ??? ???????????? ???? ?naerob LR
2U7J-M2G348-AB
WSK-M2G348-A5
???????? ????? - 5W-20
WSS-M2C948-B

Removal

  1. Refer to: Variable Valve Timing (VVT) Unit (303-01A Engine - 1.0L EcoBoost (74kW/100PS)/1.0L EcoBoost (90kW/120PS)/1.0L EcoBoost (103kW/140PS) (YY), Removal and Installation).
  1. Remove Special Service Tool: 303-1605.

Click to resize E155406

  1. cautionNOTICE: Note the position of the components before removal.

Click to resize E172731

Installation

  1. cautionNOTICE: Make sure that the mating faces are clean and free of foreign material.

    NOTE: The component must be installed within 5 minutes of applying the sealant.

Click to resize E144754

  1. cautionNOTICE: Make sure that the mating faces are clean and free of foreign material.

    NOTE: The component must be installed within 5 minutes of applying the sealant.

Click to resize E145615

  1. cautionNOTICE: Make sure that the components are installed to the position noted before removal.

  1. Install the camshafts approximately at valve overlap position cylinder No. 1.
  1. NOTE: Install all the bolts finger tight before final tightening.

    Tighten each bolt 2 turns at a time.
  1. Torque: 10 Nm
  1. Refer to: Valve Clearance Adjustment (303-01A Engine - 1.0L EcoBoost (74kW/100PS)/1.0L EcoBoost (90kW/120PS)/1.0L EcoBoost (103kW/140PS) (YY), General Procedures).

Click to resize E145658

  1. Refer to: Variable Valve Timing (VVT) Unit (303-01A Engine - 1.0L EcoBoost (74kW/100PS)/1.0L EcoBoost (90kW/120PS)/1.0L EcoBoost (103kW/140PS) (YY), Removal and Installation).

Leave a Reply

Your email address will not be published. Required fields are marked *