B-MAX 2012 – Engine – 1.4L Duratec-16V (66kW/90PS) – Camshafts – Removal and Installation

Engine - 1.4L Duratec-16V (66kW/90PS) - CamshaftsB-MAX 2012.75 (01/2012-)
Removal and Installation

Materials
NameSpecification
???????? ????? - 5W-20
WSS-M2C948-B
Flange Sealant Anaerobic LP-IMP
BU7J-M2G348-AA
WSS-M2G348-A11

Removal

  1. Remove the following items:
    • Refer to: Camshaft Seal (303-01C Engine - 1.4L Duratec-16V Flex Fuel (71kW/96PS) – Sigma, Liquefied Petroleum Gas (LPG), Removal and Installation).
  1. cautionNOTICE: Note the position of each component before removal.

Click to resize E143781

Installation

  1. goggles gloves

    NOTE: The component must be installed within 5 minutes of applying the sealant.

    Complete this step within: 5min

Click to resize E143856

  1.  
    1. 1. NOTICE:

      caution Make sure that the components are installed to the position noted before removal.

      caution Make sure that new bolts are installed.

      Bearing must be lubricated with clean engine oil.
    1. Install the camshafts approximately at valve overlap position cylinder No. 4.
    1. Tighten each bolt 0.5 turn at a time, until the components are in full contact, before final tightening.
      Torque:
      Stage 1:
      7 Nm
      Stage 2:
      45°

Click to resize E143782

  1. Measure the valve clearance and if neccessary, adjust by installing new valve tappets.
    Refer to: Valve Clearance Adjustment (303-01C Engine - 1.4L Duratec-16V Flex Fuel (71kW/96PS) – Sigma, Liquefied Petroleum Gas (LPG), General Procedures).
  1. Refer to: Camshaft Seal (303-01C Engine - 1.4L Duratec-16V Flex Fuel (71kW/96PS) – Sigma, Liquefied Petroleum Gas (LPG), Removal and Installation).

Leave a Reply

Your email address will not be published. Required fields are marked *