B-MAX 2012 – Automatic Transmission – 6-Speed PowerShift Transmission DPS6/6DCT250 – Halfshaft Seal LH – Removal and Installation

Automatic Transmission - 6-Speed PowerShift Transmission – DPS6/6DCT250 - Halfshaft Seal LHB-MAX 2012.75 (01/2012-)
Removal and Installation

Special Tool(s) / General Equipment

Click to resize E75372

204-609
Protection Cap, Ball Joint Gaiter

Click to resize E133913

205-153
Handle

Click to resize E47098

205-775
Protector, Halfshaft Seal

Click to resize E129542

307-671
Installer, Axle Seal

Click to resize 16074

308-208
Remover, Halfshaft Seal
Lower Arm Down Force Lever
Tire Lever

Removal

  1. Refer to: Wheel and Tire (204-04A Wheels and Tires, Removal and Installation).
  1. If equipped.

Click to resize E144268

Click to resize E102938

Click to resize E145097

  1. cautionNOTICE: Make sure that the strut is not moved more than necessary to prevent damage to top mount.

    Use the General Equipment: Lower Arm Down Force Lever

Click to resize E175105

  1. Install Special Service Tool: 204-609.

Click to resize E145100

Click to resize E172906

  1. NOTE: Be prepared to collect escaping fluid.

    Use the General Equipment: Tire Lever

Click to resize E173079

  1. NOTICE:

    caution Make sure that the strut is not moved more than necessary to prevent damage to top mount.

    caution The inner constant velocity (CV) joint must not be bent more than 18°.

    caution The outer constant velocity (CV) joint must not be bent more than 45°.

Click to resize E130019

Click to resize E135834

  1. Use Special Service Tool: 308-208.

Click to resize E135900

Installation

  1. cautionNOTICE: Make sure a new component is installed.

Click to resize E172907

  1. warningWARNING: Make sure that the mating faces are clean and free of corrosion and foreign material.

Click to resize E135901

  1. NOTE: Make sure that a new component is installed.

    Use Special Service Tools: 307-671, 205-153.

Click to resize E135902

  1. NOTICE:

    caution Make sure that the strut is not moved more than necessary to prevent damage to top mount.

    caution The inner constant velocity (CV) joint must not be bent more than 18°.

    caution The outer constant velocity (CV) joint must not be bent more than 45°.

    caution Take extra care not to damage the seal.

    1. Use Special Service Tool: 205-775.

Click to resize E173080

  1. cautionNOTICE: Take extra care not to damage the seal.

    Remove the special tool before completely installing the halfshaft.
    Remove Special Service Tool: 205-775.

Click to resize E129998

  1. Remove Special Service Tool: 204-609.

Click to resize E81908

  1. Use the General Equipment: Lower Arm Down Force Lever

Click to resize E175113

  1. WARNINGS:

    warning Make sure that a new bolt is installed.

    warning Make sure that a new nut is installed.

    Torque: 52 Nm

Click to resize E102188

  1. Torque: 25 Nm

Click to resize E102938

  1. Refer to: Transmission Fluid Level Check (307-01 Automatic Transmission - 6-Speed PowerShift Transmission – DPS6/6DCT250, General Procedures).
  1. Refer to: Wheel and Tire (204-04A Wheels and Tires, Removal and Installation).

Leave a Reply

Your email address will not be published. Required fields are marked *