B-MAX 2012 – Manual Transmission – 5-Speed Manual Transmission B5/IB5 – Input Shaft Seal – Removal and Installation

Manual Transmission - 5-Speed Manual Transmission – B5/IB5 - Input Shaft SealB-MAX 2012.75 (01/2012-)
Removal and Installation

Special Tool(s) / General Equipment

Click to resize 15042

205-068
Installer, Drive Pinion Bearing

Click to resize 21151

303-336
Remover, Crankshaft Rear Seal
Adhesive Tape

Removal

  1. Refer to: Clutch Slave Cylinder (308-02 Clutch Controls - 5-Speed Manual Transmission – B5/IB5, Removal and Installation).
  1. cautionNOTICE: Take extra care not to damage the bearing.

    Use Special Service Tool: 303-336.

Click to resize E104470

  1.  
    1. 2.5 x 15 mm self-tapping screw.

Click to resize E104469

Installation

  1.  
    1. 1. cautionNOTICE: Use adhesive tape to cover the input shaft splines to prevent damage to the input shaft seal.

      Install the General Equipment: Adhesive Tape
    1. NOTE: Make sure that a new component is installed.

    1. Use Special Service Tool: 205-068.
    1. Remove the General Equipment: Adhesive Tape

Click to resize E104471

  1. Refer to: Clutch Slave Cylinder (308-02 Clutch Controls - 5-Speed Manual Transmission – B5/IB5, Removal and Installation).

Leave a Reply

Your email address will not be published. Required fields are marked *