B-MAX 2012 – Engine Cooling – 1.6L Duratec-16V Ti-VCT (77kW/105PS) Sigma – Thermostat – Removal and Installation

Engine Cooling - 1.6L Duratec-16V Ti-VCT (77kW/105PS) – Sigma - ThermostatB-MAX 2012.75 (01/2012-)
Removal and Installation

General Equipment
Hose Clamp Remover/Installer

Removal

  1. Refer to: Engine Cooling System Draining, Vacuum Filling and Bleeding (303-03C Engine Cooling - 1.6L Duratec-16V Ti-VCT (77kW/105PS) – Sigma, General Procedures).
  1. Remove the following items:
    • Refer to: Generator (414-02C Generator and Regulator - 1.6L Duratec-16V Ti-VCT (77kW/105PS) – Sigma, Removal and Installation).
  1. Use the General Equipment: Hose Clamp Remover/Installer

Click to resize E89494

  1. cautionNOTICE: Note the position of the component before removal.

Click to resize E133139

Installation

  1. NOTE: Make sure that the component is installed to the position noted before removal.

Click to resize E133139

  1. NOTE: Install all the bolts finger tight before final tightening.

    Torque: 9 Nm

Click to resize E131244

  1. Use the General Equipment: Hose Clamp Remover/Installer

Click to resize E131245

  1. Install the following items:
    • Refer to: Generator (414-02C Generator and Regulator - 1.6L Duratec-16V Ti-VCT (77kW/105PS) – Sigma, Removal and Installation).
  1. Refer to: Engine Cooling System Draining, Vacuum Filling and Bleeding (303-03C Engine Cooling - 1.6L Duratec-16V Ti-VCT (77kW/105PS) – Sigma, General Procedures).

Leave a Reply

Your email address will not be published. Required fields are marked *