B-MAX 2012 – Fuel Charging and Controls – 1.5L Duratorq-TDCi (55kW/75PS) – Fuel Metering Valve – Removal and Installation Fuel Charging and Controls - 1.5L Duratorq-TDCi (55kW/75PS) - Fuel Metering ValveB-MAX 2012.75 (01/2012-)Removal and InstallationGeneral EquipmentFord approved diagnostic toolMaterialsNameSpecification?????????? ????????3U7J-2C410-AA-RemovalNOTE: Removal steps in this procedure may contain installation details.Refer to: Diesel Fuel System Health and Safety Precautions (100-00 General Information, Description and Operation).WARNINGS: Make sure that the engine is switched off. Make sure that the fuel pressure has dropped to zero and that the fuel temperature is at ambient air temperature. Wait for a minimum of 1 minute after the engine has stopped before carrying out any repair to the fuel injection system. NOTICE: Extreme cleanliness must be exercised when handling the components.Material: - (?????????? ???????? / 3U7J-2C410-AA) NOTICE: Extreme cleanliness must be exercised when handling the components. Make sure that all openings are sealed with new blanking caps. Make sure that the area around the component is clean and free of foreign material. The component must be removed by hand, the use of tools is prohibited.Torque: 6 NmInstallationTo install, reverse the removal procedure. NOTICE: Extreme cleanliness must be exercised when handling the component. Take extra care when handling the component.NOTE: Make sure that the seal is correctly located.Carry out a reset of the High Pressure Fuel System Learned Values using the following menu options: ToolBox/Powertrain/Service Functions/PCM Use the General Equipment: Ford approved diagnostic tool Bleed the fuel system if necessary. Refer to: Fuel System Bleeding (310-00E Fuel System - General Information - 1.5L Duratorq-TDCi (55kW/75PS), General Procedures).
Make sure that the engine is switched off.
NOTICE: Extreme cleanliness must be exercised when handling the components.
