Removal and Installation
NOTE: Removal steps in this procedure may contain installation details.
- Remove the following items:
Refer to: Battery
(414-01 Battery, Mounting and Cables, Removal and Installation).
NOTE: Make sure that the component terminals are not bent or damaged.
To install, reverse the removal procedure.
NOTE: This step is only necessary when installing a new component.
Refer to: Gas Control Module Calibration
(303-14C Electronic Engine Controls - 1.4L Duratec-16V Flex Fuel (71kW/96PS) – Sigma, Liquefied Petroleum Gas (LPG), General Procedures).